This is a 32" 7.5cc (.45cid) Fiberglass Outboard Racing Tunnel Hull Boat by
Prather.

FEATURES: Epoxy fiberglass hull
          Factory joined deck and hull
          Removable epoxy fiberglass hatch cover
          Foam flotation
          Aluminum turn fin included
          Plywood transom plate factory installed
          Plywood turn fin plate factory installed
          Complete instructions with photos

INCLUDES: Hull, deck and hatch, turn fin, decals, partial hardware package

SPECS:    Length: 32"
          Beam: 13-1/2"
          Tunnel Width: 7"
          Engine: 7.5cc (.45cu. in.)
REQUIRES: Accessory Kit  (PRAB3012)
          2 Ch radio w/ one hi-torque servo
          7.5cc Outboard Engine
          15min Epoxy and CA glue
          Filler Putty
          Prop Balancer
          Silver Solder
          Fuel
          Electric starter, glow heater
          12v battery, charger
          Epoxy paint, sandpaper, masking tape
          Propeller grease (PRAB2045)

REQUIRED  Sandpaper and sanding block
   TOOLS: Screw drivers
          Dremel tool with metal cutter
          Drill and Bits (1/16', 1/8", 5/32",5/64",7/32", 11/64", #43)
          1/2" file
          Pliers
          Soldering
          4-40 tap